Steering Linkage Test
Steering Linkage1. NOTE: Excessive vertical motion of the studs relative to the sockets may indicate excessive wear.
With the vehicle on the ground and the parking brake applied, start the vehicle and carry out the following:
^ Have an assistant rotate the steering wheel back and forth 360 degrees and watch for relative motion of the studs in the steering linkage ball sockets.
^ Watch for loose steering gear mounting.
2. An additional check is with the KOEO and the front wheels raised off the ground, grasp the wheel at the front and rear and watch for excessive play or binding in the joints while trying to steer the wheels.
3. NOTE: Incorrect separation of the tapered stud from its seat will cause premature failure of the ball socket.
Steel, greaseable joints can be checked for excessive wear by measuring the torque it takes to turn the stud.
1 Separate the tapered stud from its seat and thread the attaching nut back onto the stud.
2 Turn the stud with an inch - pound torque wrench and note the torque required to turn the stud.
4. Some joint turning torques will be as little as 0.2 Nm (2.0 inch lbs.) within the first 1,600 km (1,000 miles) and will remain there for the life of the joint.
5. Only install a new joint if it requires less than 0.2 Nm (2.0 inch lbs.) and has any play when moved by hand.
6. Install new components if necessary. Tighten any worn, damaged, or loose components.