Test A: Transmission Fluid Pressure Sensors

PINPOINT TEST A: TRANSMISSION FLUID PRESSURE SENSORS

Test A1:

Test A1-A7:

Test A8:

NOTE: An incorrectly installed transmission fluid pan filter, or cut or damaged O-rings on the mechatronic assembly feed tubes can cause a difference in the pressure readings. Always check the fluid pan filter for correct installation and check the mechatronic feed tubes for damage prior to installing a new or the original mechatronic assembly. If damage to the mechatronic feed tube O-rings, or the fluid filter is found to be installed incorrectly, repair as required. Install the mechatronic assembly and check the pressure using this pinpoint test. If the pressure readings are still incorrect, install a new mechatronic assembly.

NOTE: The transmission control module (TCM) is integrated into the mechatronic assembly. If installing a new transaxle or a mechatronic assembly, the TCM will need to be checked and recalibrated (reflashed) to the latest level calibration available.