OTC - Stall Test

1. With Pressure Gauge connected, turn the ignition switch to the ON position.
2. Shift the gearshift lever to the R position.
3. Read and record the line pressure at idle.
4. Press the accelerator to the floor Wide Open Throttle (WOT).

CAUTION: The following step must be completed within 5 seconds, followed by cooling the Automatic Transmission Fluid (ATF). The ATF can be cooled by placing the automatic transmission in neutral (N) for one minute while the engine is at idle. Otherwise damages to the automatic transmission may occur.

5. Read and record the engine rpm.
6. Release the accelerator pedal.
7. Repeat Operational Test OTC - Stall Test for the following gearshift lever positions: overdrive, D, and L.

CAUTION: Cool the ATF between each gear position being tested.

8. Compare the test results with the Stall Test Evaluation Chart. Stall Test specification should be between 2400 - 2700 rpm.

Part 3 Of 4:

9. If the Stall Test result is within specification, go to Operational Test OTD - Time Lag Test.