Arming and Disarming

WARNINGS:
^ TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP POWER SUPPLY MUST BE DEPLETED BEFORE REPAIRING OR REPLACING ANY AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) COMPONENTS. TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT ONE MINUTE. BE SURE TO DISCONNECT AUXILIARY BATTERIES AND POWER SUPPLIES (IF EQUIPPED).

^ CARRY A LIVE AIR BAG MODULE WITH THE AIR BAG AND TRIM COVER POINTED AWAY FROM YOUR BODY. THIS WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN ACCIDENTAL DEPLOYMENT.

^ DO NOT SET A LIVE AIR BAG MODULE DOWN WITH THE TRIM COVER FACE DOWN.

^ THE AIR BAG SIMULATOR MUST BE REMOVED AND THE AIR BAG RECONNECTED WHEN THE SYSTEM IS REACTIVATED TO AVOID NON-DEPLOYMENT IN A COLLISION RESULTING IN POSSIBLE PERSONAL INJURY.

Deactivation Procedure
1. Record USER 1 and USER 2 pre-set radio frequencies for reprogramming following completion of service procedure.
2. Disconnect battery ground cable.
3. Wait one minute for backup power supply in air bag Electronic Crash Sensor (ECS) module to deplete stored energy.
4. Remove driver air bag module from vehicle.




5. Connect Rotunda Air Bag Simulator 418-F088 (105-R0012) or equivalent to vehicle harness at top of steering column.
6. Remove passenger air bag module. Install Rotunda Air Bag Simulator 418-F088 (105-R0012) or equivalent on vehicle harness connector in place of passenger air bag module.
7. Reconnect battery ground cable.

Reactivation Procedure
1. Disconnect battery ground cable.
2. Wait one minute for backup power supply in air bag Electronic Crash Sensor (ECS) module to deplete stored energy.
3. Remove Rotunda Air Bag Simulator 418-F088 (105-R0012) or equivalent from vehicle harness connector at top of steering column.
4. Install driver air bag module.
5. Remove Rotunda Air Bag Simulator 418-F088 (105-R0012) or equivalent from vehicle harness connector at the passenger air bag. Reconnect and install passenger air bag module.
6. Reconnect battery ground cable.
7. Prove out system.
8. Reprogram USER 1 and USER 2 preset radio frequencies and set clock.