H2 Check Hydraulic Pressure

NOTE: This test requires an assistant. The pressure reduction operation occurs within a 2 second period.

- Raise and support the vehicle.

- Shift the transaxle to NEUTRAL (M/T) or N (A/T).

- Release the parking brake.

- Check to see that there is no brake drag while rotating the wheels by hand.

- Use a jumper wire to connect the "TBS" and "GND" terminals at the data link connector.

- Depress the brake pedal and have an assistant verify that the wheels will not rotate.

Testing:

- With the brake pedal still depressed, turn the key ON and verify that the brake pressure is released momentarily (approximately 0.5 seconds) and that each wheel rotates when pressure reduction operates as shown.

- Does the pressure reduction operate properly?

YES -- If directed to this pinpoint test from quick test step QT4, ABS is functioning properly.

If directed to this Pinpoint Test from Step A8, intermittent fault. Go to Continuous Test. QT9 Perform Continuous Test

If directed to this Pinpoint Test from Step C3, Go to Pinpoint Test G1. G1 Check ABS Brake Indicator Operation

NO -- Inspect hydraulic system piping and wiring. If OK, replace hydraulic anti-lock actuator assembly.