P3 Check ABS Operation RH Front Wheel

- Jump pins 19 and 34 at breakout box.

- Short pins 38, 21 and 60 to each other at breakout box.

- Apply moderate brake pedal effort. Check that RH front wheel will not turn with ignition switch OFF.

CAUTION: Do not leave ignition ON for more than one minute or valve damage may result.

- Check that RH front wheel turns freely with ignition ON.

- Does wheel turn freely?

YES -- Turn ignition switch OFF. Disconnect wire leads. Go to P4. P4 Check ABS Operation RH Rear Wheel

NO -- Verify correct wiring between 55-pin connector and 16-pin connector on valve block. If wiring is correct, Replace solenoid valve block. Restore vehicle. Retest system.