Initial Inspection and Diagnostic Overview

The anti-lock brake control module is capable of performing an on-board diagnostic using Rotunda Super STAR II Tester 007-0041B or equivalent.

If the Super STAR II Tester is not available, the Anti-Lock Quick Check Sheet should be used. Pinout Values and Diagnostic Parameters

The anti-lock brake control module monitors system operation and can store all defined Diagnostic Trouble Codes (DTCs) in its memory. It is important to understand that the anti-lock brake control module cannot recognize some failures. Therefore if a symptom exists and no diagnostic trouble codes are stored by the anti-lock brake control module, other diagnostic steps must be followed.

The anti-lock brake control module cannot store a diagnostic trouble code if there is no power to the anti-lock brake control module. This condition can be found by using the Quick Check Sheet. Pinout Values and Diagnostic Parameters

DTCs 18, 19 and 20 series codes will override any other stored DTC and will not allow other DTCs to be output if the failure exists while the on-board diagnostic is being run. If the failure is intermittent or if the DTC was left in the anti-lock brake control module due to improper erasing procedures, the DTC will be output during on-board diagnostic but the next DTC will also be output.