P4 Check ABS Operation RH Rear Wheel

- Jump pins 19 and 34 at breakout box.

- Short pins 55, 18 and 60 to each other at breakout box.

- Apply moderate brake pedal effort. Check that RH rear wheel will not turn with ignition switch OFF.

CAUTION: Do not leave ignition ON for more than one minute or valve damage may result.

- Check that RH rear wheel turns freely with ignition switch ON.

- Does wheel turn freely?

YES -- Turn ignition switch OFF. Disconnect wire leads. Go to P5. P5 Check ABS Operation LH Rear Wheel

NO -- Verify correct wiring between 55-pin connector and 16-pin connector on valve block. If wiring is correct, Replace solenoid valve block. Restore vehicle. Retest system.