TP3 - Check Wires to PCM

- Key OFF.

- Install Breakout Box (leave PCM disconnected).

- Disconnect the TP sensor connector.

- Measure the resistances of the TP wire and SIGRTN wire between BOB Test Pins and the TP sensor harness connector.

- Measure the resistance of the TP wire between BOB Test Pin TP and ground.

- Are the resistances less than 5 ohms between BOB Test Pins and the TP sensor harness connector, and greater than 10,000 ohms between BOB Test Pin TP and ground?

Yes -- Replace the throttle position sensor.

No -- Service the wire(s) in question.