J3 Check ABS Operation RH Front Wheel

- Jump pins 19 and 34 at breakout box.

- Short pins 38, 21 and 60 to each other at breakout box.

- Apply moderate brake pedal effort. Check that RH front wheel will not turn with ignition switch OFF.

- Does RH front wheel turn freely with ignition switch in RUN?

CAUTION: Do not leave ignition switch in RUN for more than 1 minute or valve damage may result.

YES -- Turn ignition switch OFF. Disconnect wire leads. Go to J4. J4 Check ABS Operation RH Rear Wheel

NO -- Verify correct wiring between 55-pin connector and 19-pin connector on brake pressure control valve block. If wiring is correct, replace brake pressure control valve block.