5: Removing Tester & Clearing Codes

Rotunda Transmission Tester

Step1
Preliminary Testing and Diagnosis
1: Preliminary Testing and Diagnosis

Step2
Transmission Tester Installation (Set-Up Procedures)
2: Installing the Transmission Tester

Step 3
Static Testing - Engine OFF
3: Static Testing - Engine OFF

Step 4
Dynamic Testing - Engine Running
4: Dynamic Testing - Engine Running

Step 5
Transmission Tester Removal and Clearing DTCs

CAUTION: Do not attempt to pry off connectors with a screwdriver. This will damage the connectors and could result in a transaxle concern.

1. Disconnect transmission tester from transaxle connector.
2. Install vehicle wiring harness connector. Verify connection by pulling up on the harness.
3. Install all heat shields that were previously removed.
4. Disconnect transmission tester power lead from cigar lighter.
5. Erase all DTCs (unlatch center button of SUPER STAR Tester II while DTCs are being displayed during KOEO).
6. Rerun On-Board Diagnostics to receive a pass code (111).
7. Verify that the customer concern has been eliminated.