TA5 - Check PNP/CPP Switch

- Key "OFF".

- Breakout box installed, Powertrain Control Module (PCM) disconnected.

- Locate Park Neutral Position (PNP) switch (on transmission) and Clutch Pedal Position (CPP) switch (at clutch pedal linkage).

- Disconnect vehicle harness at both switches and inspect connectors for pushed back pins.

- Measure resistance across the PNP switch terminals with transmission in "NEUTRAL" and across the CPP switch terminals with the clutch pedal "DOWN".

- Is each resistance less than 5.0 ohms?

Yes -- Go to TA6. TA6 - Check PNP/CPP Harness

No -- Replace open switch. Remove breakout box. Reconnect all components. Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)