KM31 - Check A/C Input Circuit

- Key "OFF".

- Disconnect Powertrain Control Module (PCM). Inspect for damaged or pushed out pins, corrosion, loose wires, etc. Service as necessary.

- Install breakout box, leave PCM disconnected.

- Key "ON", engine "OFF".

- A/C "ON".

- Measure voltage between test pin 10 and test pin 40 at the breakout box.

- Is voltage greater than 10.5 volts?

Yes -- Replace PCM. Remove breakout box. Reconnect all components. Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)

No -- Service open in A/C circuit. Remove breakout box. Reconnect all components. Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)