TE10 - KOEO and KOER DTC 0713: Attempt to Induce Opposite

Diagnostic Trouble Code (DTC) 0713 indicates that self-test has detected a TFT sensor circuit input above the maximum acceptable voltage.

Possible Causes:
- Fluid level not to specifications.
- Damaged TFT sensor.
- Short to VPWR in TFT SIG harness circuit.
- Open in TFT SIG or SIG RTN harness circuit.
- Damaged PCM.

- Key Off.

- Disconnect transmission bulkhead connector at the TFT sensor. inspect for damaged or pushed out pins, corrosion, loose wires, etc. Service as necessary.

- Insert a jumper wire from TFT SIG circuit to SIG RTN circuit at the transmission vehicle harness connector.

- Activate Key On Engine Off (KOEO) and Key On Engine Running (KOER) Self-Tests.

- Is DTC 0712 present?

NOTE: Disregard any other DTCs generated at this time. if NO DTCs are generated (module not responding), then immediately GO to step TE12. TE12 - Check For TFT SIG Circuit Short to Power

YES -- The fault that produced DTC 0713 is not within the TFT harness circuits or the PCM. REMOVE jumper wire. REFER to Transmission and Drivetrain for TFT sensor service.

NO -- The opposite condition could not be induced. REMOVE jumper wire. GO to TE11. TE11 - Check Continuity of TFT SIG and SIG RTN Circuits