Diagnostic Trouble Code (DTC) Memory

TEST PREPARATION FOR DTC READOUT

1. Connect Hand-Held Tester (HHT) to data link connector (X11/4) according to connection diagram. Connecting HHT
2. Ignition: ON.
3. Read DTC memory for transmission control module (N15/1). (If no DTC's are stored in DTC memory which are relative to the complaint, perform entire Electrical Test Program. ETP - Electrical Test Program

Special Tools:

Trouble Code Charts

002 - 005:

006 - 010:

1) Observe Preparation for Test. Preparation For Test
2) If DTC 9 is displayed, it may be attributable to previous repair work done on the vehicle. For example, the valve block connector (Y3/1x1) on the transmission was not connected/reconnected while the engine was idling > 1,000 rpm. Clear DTC 9 by using HHT. Start engine and idle at > 1,000 rpm for approximately 10 seconds, check DTC with HHT, if DTC 9 reappears, see test step for DTC 9.0. Test Steps (=>)