Evaporative Emission Control Canister: Service and Repair

CHARCOAL CANISTER REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5]

Except for Mexico

1. Remove in the order indicated in the table.










2. Install in the reverse order of removal.

Charcoal canister removal note

1. Remove the rear stabilizer. Rear Suspension - Stabilizer Removal/Installation

2. Remove the rear coil spring. Rear Suspension - Coil Spring Removal/Installation

3. Remove the rear lower arm. Rear Suspension - Lower Arm Removal/Installation

4. Remove the rear crossmember component. Service and Repair

5. Remove the charcoal canister.

Charcoal canister bracket removal note

NOTE:
- The charcoal canister bracket is installed using rivets.

1. Push out the mandrel using a hammer and punch (2-2.8 mm {0.08-0.11 in} diameter).






2. Remove the flange using a drill (5 mm {0.20 in} drill bit).






Mexico

1. Remove in the order indicated in the table.










2. Install in the reverse order of removal.