DTC Inspection - Instrument Cluster

DTC INSPECTION [INSTRUMENT CLUSTER]

1. Connect the M-MDS (IDS) to the DLC-2.






2. After the vehicle is identified, select the following items from the initialization screen of the IDS.
a. Select "Self Test".

b. Select "Modules".

c. Select "IC".

3. Verify the DTC according to the directions on the screen.

- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection after recording the snapshot data.

4. After completion of repairs, clear all DTCs stored in the instrument cluster. Clearing DTC - Instrument Cluster

Snapshot Data Table

NOTE:
- Snapshot data items are not displayed, according to detected DTC.