Front Seat Cover Removal/Installation - Vehicles With Power Seat System

FRONT SEAT COVER REMOVAL/INSTALLATION [VEHICLES WITH POWER SEAT SYSTEM]

WARNING:
- Handling a front seat (with built-in side air bag) improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings before handling a front seat (with built-in side air bag). Air Bag System Service Warnings

CAUTION:
- After removing a front seat, do not operate the slider lever. If the slider lever is operated, the left and right slide positions will deviate, and the slide adjuster may be damaged after the front seat is installed.
- Verify that there are no malfunctions in the sliding mechanism after installing a front seat.
- When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean rag so as not to damage or soil the seat.
- When the passenger's seat is removed, perform the seat weight sensor inspection using the M-MDS after installing the passenger's seat. Component Tests and General Diagnostics
- When the passenger's seat is replaced with a new one, perform the seat weight sensor calibration using the M-MDS. Programming and Relearning

Side Cover

1. Switch the ignition to off.

2. Remove the battery cover. Removal and Replacement Removal and Replacement Removal and Replacement

3. Disconnect the negative battery cable and wait 1 min or more. Removal and Replacement Removal and Replacement Removal and Replacement

4. Remove the front seat. (See Removal and Replacement.)

5. Pull the power seat switch knobs in the direction of arrow, while remove the hook.






6. Pull the side cover (front door side) in the order of (1), (2), (3) shown in the figure to disengage the fastener, hook and tab.






7. Remove the front seat side cover (front door side).

8. Pull the side cover (rear console side) in the order of (4), (5) shown in the figure to disengage the fastener and tab.






9. Remove the front seat side cover (rear console side).

10. Install in the reverse order of removal.

Front Cover

1. Remove the screws.






2. Remove the front cover.

3. Install in the reverse order of removal.