Removal and Replacement

OIL COOLER REMOVAL/INSTALLATION [FS5A-EL]

Type A

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable.

3. Remove the air cleaner component. Service and Repair

4. Remove the aerodynamic under cover NO.2. Aerodynamic Under Cover No.2 Removal/Installation

5. Drain the ATF. Procedures

6. Drain the engine coolant. Service and Repair

7. Remove in the order indicated in the table.










8. Install in the reverse order of removal.

9. Add the engine coolant. Service and Repair

10. Add the ATF. Procedures

11. Perform the "Mechanical System Test". Mechanical System Test [FS5A-EL]

Oil Hose Installation Note

NOTE:
- If reusing the hose, install the new hose clamp exactly on the mark left by the previous hose clamp. Then apply force to the hose clamp in the direction of the arrow in order to fit the clamp in place.

1. Align the marks, and slide the oil hose onto the oil pipe until it is fully seated as shown.






2. Install the hose clamp.

3. Install the hose clamp onto the hose.






4. Verify that the hose clamp does not interfere with any other components.

Type B

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable.

3. Remove the air cleaner component. Service and Repair

4. Remove the aerodynamic under cover NO.2. Aerodynamic Under Cover No.2 Removal/Installation

5. Remove the front splash shield (LH). Splash Shield Removal/Installation

6. Remove the front mudguard (LH). Service and Repair

7. Drain the ATF. Procedures

8. Drain the engine coolant. Service and Repair

9. Remove in the order indicated in the table.










10. Install in the reverse order of removal.

11. Add the engine coolant. Service and Repair

12. Add the ATF. Procedures

13. Perform the "Mechanical System Test". Mechanical System Test [FS5A-EL]

Oil Hose Installation Note

NOTE:
- If reusing the hose, install the new hose clamp exactly on the mark left by the previous hose clamp. Then apply force to the hose clamp in the direction of the arrow in order to fit the clamp in place.

1. Align the marks, and slide the oil hose onto the oil pipe until it is fully seated as shown.






2. Install the hose clamp.

3. Install the hose clamp onto the hose.






4. Verify that the hose clamp does not interfere with any other components.