Fuel Pump Ballast Resistor: Service and Repair

FUEL PUMP RESISTOR REMOVAL/INSTALLATION [L3 WITH TC]

1. Remove the battery cover. (See Removal and Replacement.)

2. Disconnect the negative battery cable.

3. Remove the air cleaner. Service and Repair

4. Disconnect the fuel pump resistor connector.






5. Remove in the fuel pump resistor.

6. Install in the order as shown in the figure.






Tightening torque
- 7.8-11.8 Nm {80-120 kgf-cm, 70-104 in-lbf}

7. Connect the fuel pump resistor connector.