Roof Opening Panel Glass - Front Sliding

Roof Opening Panel Glass - Front Sliding

Removal and Installation

NOTE: The roof opening panel motor(s) must be initialized when repairs are carried out on any part of the roof opening panel system, including: whenever the roof opening panel sliding glass motor or power shade motor has been removed from the roof opening panel system, the roof opening panel glass has been removed from the roof opening panel system, the roof opening panel assembly has been removed from the vehicle, a new roof opening panel motor has been installed, a new roof opening panel glass has been installed or a new roof opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization Programming and Relearning.

1. Position the front sliding glass panel to the CLOSED position and the power shade to the full OPEN position.

2. Remove the 4 front sliding glass panel screws.
- To access the glass screws, unclip the top portion of the concertina blind and slide the concertina blind rearward as necessary.

- To install, tighten to 5 Nm (44 lb-in) and make sure the concertina blind is clipped correctly back in place.

3. From the outside of the vehicle, remove the front sliding glass panel assembly.

4. To install, reverse the removal procedure.
- Check for correct alignment of the front sliding glass panel. For additional information, refer to Roof Opening Panel Alignment Adjustments.

- Initialize the front sliding glass panel motor. For additional information, refer to Roof Opening Panel Motor Initialization Programming and Relearning.