Removal

1UR-FSE EXHAUST: EXHAUST MANIFOLD (for 2WD): REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

4. REMOVE AIR CLEANER INLET COVER Removal

5. REMOVE NO. 1 AIR CLEANER INLET Removal

6. REMOVE INTAKE AIR CONNECTOR PIPE Removal

7. REMOVE V-RIBBED BELT Removal

8. REMOVE ENGINE ROOM SIDE COVER RH Removal

9. REMOVE ENGINE ROOM SIDE COVER LH Removal

10. REMOVE NO. 1 ENGINE UNDER COVER Service and Repair

11. REMOVE FRONT SUSPENSION MEMBER PROTECTOR LOWER Removal

12. REMOVE NO. 2 ENGINE UNDER COVER Removal

13. REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR Removal

14. REMOVE NO. 1 DIFFERENTIAL SUPPORT PROTECTOR Removal

15. REMOVE NO. 6 ROCKER PANEL MOULDING PROTECTOR Removal

16. REMOVE NO. 5 ROCKER PANEL MOULDING PROTECTOR Removal

17. REMOVE REAR FLOOR SIDE MEMBER COVER LH Removal

18. REMOVE REAR FLOOR SIDE MEMBER COVER RH Removal

19. REMOVE FRONT FLOOR COVER LH Removal

20. REMOVE FRONT FLOOR COVER RH Removal

21. REMOVE FRONT FLOOR CENTER BRACE Removal

22. DISCONNECT HEATED OXYGEN SENSOR Removal

23. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal

24. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY Removal

25. REMOVE FRONT WHEEL

26. REMOVE FRONT STABILIZER LINK ASSEMBLY LH Removal

27. REMOVE FRONT STABILIZER LINK ASSEMBLY RH Removal

28. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY LH Removal

29. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY RH Removal

30. REMOVE REAR ENGINE UNDER COVER LH Removal

31. REMOVE REAR ENGINE UNDER COVER RH Removal

32. REMOVE FRONT STABILIZER NO. 1 BRACKET LH Removal

33. REMOVE FRONT STABILIZER NO. 1 BRACKET RH Removal

34. REMOVE FRONT STABILIZER BAR Removal

35. REMOVE FRONT STABILIZER BAR NO. 1 BUSH Removal

36. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT LH Removal

37. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH Removal

38. REMOVE GENERATOR ASSEMBLY Removal

39. REMOVE STEERING SLIDING YOKE WITH SHAFT SUB-ASSEMBLY (w/ VGRS) Removal

40. REMOVE STEERING SLIDING YOKE WITH SHAFT SUB-ASSEMBLY (w/o VGRS) Removal

41. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (w/ VGRS) Removal

42. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (w/o VGRS) Removal

43. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE Removal

44. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

(a) Disconnect the air fuel ratio sensor connector.





(b) Remove the 3 bolts and No. 1 exhaust manifold heat insulator.





45. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

(a) Remove the 8 nuts and exhaust manifold RH.





(b) Remove the gasket.





46. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

(a) Disconnect the air fuel ratio sensor connector.





(b) Remove the 3 bolts and No. 2 exhaust manifold heat insulator.





47. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

(a) Remove the 8 nuts and exhaust manifold LH.





(b) Remove the gasket.





48. REMOVE AIR FUEL RATIO SENSOR (for Bank 1) Removal

49. REMOVE AIR FUEL RATIO SENSOR (for Bank 2) Removal