Replacement

1UR-FSE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL (for 2WD): REPLACEMENT

1. DISCHARGE FUEL SYSTEM PRESSURE Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

(a) Remove the automatic transmission Removal.

4. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY Removal

5. REMOVE ENGINE REAR OIL SEAL

(a) Remove the oil seal with a screwdriver.





HINT
Tape the screwdriver tip before use.

NOTICE:
Do not damage the surface of the oil seal press fit hole and crankshaft.

6. INSTALL ENGINE REAR OIL SEAL

(a) Using SST, tap in a new oil seal until its surface is flush with the oil seal retainer edge.





SST : 09223-15030

SST : 09950-70010

09951-07150

NOTICE:
* Keep the lip free from foreign matter.
* Do not tap on the oil seal at an angle.

7. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY Installation

8. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

(a) Install the automatic transmission Installation.

9. PERFORM INITIALIZATION

(a) Preform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.