Installation

DRIVE SHAFT: REAR DRIVE SHAFT ASSEMBLY: INSTALLATION

1. INSTALL REAR DRIVE SHAFT ASSEMBLY LH

(a) Coat the spline of the inboard joint shaft with gear oil.

(b) Set the shaft snap ring with the opening side facing downward.

(c) Align the shaft splines and install the drive shaft with a brass bar and hammer.





NOTICE:
* Be careful not to damage the drive shaft dust cover, boot and oil seal.
* Move the drive shaft while keeping it level.

HINT
Whether the inboard joint shaft is in contact with the pinion shaft or not can be checked from the sound or feeling when driving it in.

2. INSTALL REAR DRIVE SHAFT ASSEMBLY RH

HINT
Use the same procedures described for the LH side.

3. INSTALL REAR AXLE ASSEMBLY LH

(a) Install the rear axle assembly LH Installation.

4. INSTALL REAR AXLE ASSEMBLY RH

HINT
Use the same procedures described for the LH side.

5. INSTALL REAR SUSPENSION MEMBER BRACE LH

(a) Install the rear suspension member brace with the 2 bolts.





Torque : 50 Nm (510 kgf-cm, 37 ft-lbf)

6. INSTALL REAR SUSPENSION MEMBER BRACE RH

(a) Install the rear suspension member brace with the 2 bolts.





Torque : 50 Nm (510 kgf-cm, 37 ft-lbf)

7. INSTALL NO. 1 DIFFERENTIAL SUPPORT PROTECTOR

(a) Install the support protector with the 3 nuts.





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

8. INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR

(a) Install the support protector with the 3 nuts.





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

9. ADD DIFFERENTIAL OIL Testing and Inspection