Installation

AXLE: STEERING KNUCKLE (for AWD): INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
* A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

(a) Install the front axle hub to the steering knuckle with the 4 bolts.





Torque : 65 Nm (663 kgf-cm, 48 ft-lbf)

2. INSTALL STEERING KNUCKLE SUB-ASSEMBLY LH

(a) Install the steering knuckle to the front lower ball joint with the 3 bolts.





Torque : 113 Nm (1149 kgf-cm, 83 ft-lbf)

3. CONNECT FRONT NO. 1 SUSPENSION UPPER ARM ASSEMBLY LH Installation

4. CONNECT FRONT NO. 2 SUSPENSION UPPER ARM ASSEMBLY LH Installation

5. CONNECT TIE ROD ASSEMBLY LH Installation

6. INSTALL FRONT SPEED SENSOR LH Installation

7. CONNECT SKID CONTROL SENSOR WIRE Installation

8. INSTALL FRONT DISC BRAKE DUST COVER LH Installation

9. INSTALL FRONT DISC Installation

10. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH Installation

11. INSTALL FRONT AXLE SHAFT NUT LH Installation

12. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH Removal

13. REMOVE FRONT DISC Removal

14. INSPECT FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub

15. INSPECT FRONT AXLE HUB RUNOUT Front Axle Hub

16. INSTALL FRONT DISC Installation

17. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH Installation

18. STAKE FRONT AXLE SHAFT NUT LH Installation

19. INSTALL FRONT WHEEL Installation

20. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Inspect and adjust the front wheel alignment Front Wheel Alignment.

21. CHECK ABS SPEED SENSOR SIGNAL

(a) Check the speed sensor signal Test Mode Procedure.

22. ADJUST VEHICLE HEIGHT

(a) Adjust the vehicle height Adjustments.

23. ADJUST HEADLIGHT ASSEMBLY

(a) Adjust the headlight Adjustments.