Inspection

SUSPENSION: FRONT LOWER SUSPENSION ARM (for AWD): INSPECTION

1. INSPECT FRONT NO. 2 SUSPENSION LOWER ARM





(a) Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.

(b) Use a torque wrench to turn the nut continuously at a rate of 3 to 5 seconds per turn. Take the torque reading on the fifth turn.

Standard turning torque:

3.0 N*m (30.6 kgf*cm, 26.6 in.*lbf)

If the result is not as specified, replace the front No. 2 suspension lower arm.

(c) Check the dust boot for cracks or grease leakage.