Installation

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.
* A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY





(a) Install the seat belt with the 2 bolts. First install the upper bolt, and then install the lower bolt.

Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

2. INSTALL HEIGHT ADJUSTABLE ANCHOR MOTOR LH





(a) Insert the motor into the adjuster as shown in the illustration.

(b) Install the connector.

3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH





NOTICE:
When installing the retractor, make sure the vehicle's claws (labeled "a" in the illustration) only contact the installation areas of the retractor.

(a) Align the vehicle's claws with the seat belt retractor positioning holes.

(b) Install the seat belt with the 2 bolts. First install the upper bolt, and then install the lower bolt.

for bolt A - Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)

for bolt B - Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)





(c) Connect the pretensioner connector labeled A, as shown in the illustration.

(d) Connect the tension reducer connector labeled B.

(e) w/ Pre-collision system:

Connect the pre-collision connector labeled C.





(f) Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.

Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

4. INSTALL FRONT SEAT SHOULDER BELT GUIDE





(a) Install the belt guide with the 2 screws.

NOTICE:
Make sure the belt is not pinched as this may damage the belt.

5. INSTALL CENTER UPPER PILLAR GARNISH LH Installation

6. INSTALL CENTER LOWER PILLAR GARNISH LH Installation

7. INSTALL REAR DOOR SCUFF PLATE LH

(a) for Standard Body:

(1) Install the rear door scuff plate Installation.

(b) for Long Body:

(1) Install the rear door scuff plate Installation.

8. INSTALL FRONT DOOR SCUFF PLATE LH Installation

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

10. INSTALL COWL TOP VENTILATOR LOUVER RH Installation

11. INSTALL FRONT SEAT ASSEMBLY

(a) Install the front seat assembly Installation.

12. CONNECT FRONT SEAT OUTER BELT ASSEMBLY Installation

13. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.