Installation

SEAT BELT: FRONT SEAT INNER BELT ASSEMBLY: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. INSTALL FRONT SEAT INNER BELT ASSEMBLY





(a) Install the front seat inner belt assembly with the nut.

Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

NOTICE:
Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding parts of the front seat adjuster.





(b) for Driver Seat:

Connect the 3 connectors and attach the 5 clamps.

(c) for Passenger Seat:

Connect the 2 connectors and attach the clamp.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. INSTALL FRONT SEAT ASSEMBLY

(a) Install the front seat assembly Installation.

4. INSTALL COWL TOP VENTILATOR LOUVER RH Installation

5. CONNECT FRONT SEAT OUTER BELT ASSEMBLY Installation

6. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.