Removal

SUPPLEMENTAL RESTRAINT SYSTEM: SPIRAL CABLE: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* w/ Navigation System (for HDD):
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

3. REMOVE SWITCH AND VOLUME CASE Removal

4. REMOVE LOWER NO. 2 STEERING WHEEL COVER Removal

5. REMOVE STEERING PAD Removal

6. REMOVE STEERING WHEEL ASSEMBLY Removal

7. REMOVE STEERING COLUMN COVER (w/o Driver Monitor Camera) Removal

8. REMOVE STEERING COLUMN COVER (w/ Driver Monitor Camera) Removal

9. REMOVE SPIRAL CABLE SUB-ASSEMBLY

(a) Disconnect the connectors from the spiral cable with steering angle sensor.





NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Detach the 3 claws and remove the spiral cable with steering angle sensor.

10. REMOVE STEERING SENSOR

(a) Detach the 6 claws and remove the spiral cable.