Rear Vanity Light Does Not Illuminate

LIGHTING: LIGHTING SYSTEM: Rear Vanity Light does not Illuminate
- Rear Vanity Light does not Illuminate

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (MAP LIGHT - BATTER AND BODY GROUND)

(a) Disconnect the X4 and X6 light connectors.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (MAP LIGHT - REAR VANITY LIGHT)

(a) Disconnect the X4, X6, X11 and X14 light connectors.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

for LH
for RH

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. CHECK REAR VANITY LIGHT ASSEMBLY (OPERATION)

(a) Check that the malfunction disappears when the rear vanity light is replaced with a normal one Removal.

OK:

Malfunction disappears

NG -- REPLACE MAP LIGHT ASSEMBLY Removal

OK -- REPLACE REAR VANITY LIGHT ASSEMBLY Removal