Installation

1UR-FSE EXHAUST: EXHAUST MANIFOLD (for AWD): INSTALLATION

1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

(a) Using SST, install the air fuel ratio sensor to the exhaust manifold LH.





SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

HINT
* Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
* Make sure SST and the torque wrench are connected in a straight line.

2. INSTALL AIR FUEL RATIO SENSOR NO.2 (for Bank 2 Sensor 1)

(a) Using SST, install the air fuel ratio sensor to the exhaust manifold RH.

SST : 09224-00010





without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

HINT
* Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
* Make sure SST and the torque wrench are connected in a straight line.

3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH

(a) Place a new gasket on the cylinder head with the "B" mark facing the manifold side.





NOTICE:
Make sure that the gasket is installed facing the proper direction.

(b) Install the exhaust manifold with the new nuts by uniformly tightening the nuts in several steps, in the sequence shown in the illustration.





Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

(c) Connect the air fuel ratio sensor connector.





(d) Hook the wire harness to the bracket.

4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH

(a) Place a new gasket on the cylinder head with the "B" mark facing the manifold side.





NOTICE:
Make sure that the gasket is installed facing the proper direction.

(b) Install the exhaust manifold with the new nuts by uniformly tightening the nuts in several steps, in the sequence shown in the illustration.





Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

(c) Connect the air fuel ratio sensor connector.





(d) Hook the wire harness to the bracket.

5. INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET LH Installation

6. INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET RH Installation

7. INSTALL FRONT ENGINE MOUNTING INSULATOR Installation

8. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

(a) Install the heat insulator with the 3 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)





9. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

(a) Install the heat insulator with the 3 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)





10. INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE Installation

11. INSTALL FRONT FRAME ASSEMBLY Installation

12. INSTALL ENGINE AND TRANSMISSION

(a) Install the engine and transmission Installation.