Removal

MIRROR: OUTER REAR VIEW MIRROR: REMOVAL

HINT
* Use the same procedures for the LH side and RH side.
* The procedures listed below are for the LH side.

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
* w/ Navigation System (for HDD):
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly

4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY Disassembly

5. REMOVE DOOR FRAME GARNISH Disassembly

6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

7. REMOVE MULTIPLEX NETWORK FRONT DOOR ECU Disassembly

8. REMOVE FRONT NO. 2 DOOR SERVICE HOLE COVER Disassembly

9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY





(a) Disconnect the connector.

(b) Detach the 3 clamps.

(c) Remove the 3 nuts and mirror.