Removal

AUDIO / VISUAL: REAR DOOR SPEAKER (for Standard Body): REMOVAL

HINT
* Use the same procedures for the LH side and RH side.
* The procedures listed below are for the LH side.

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
* w/ Navigation System (for HDD):
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH Removal

4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY Removal

5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Removal

6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY (w/ Rear Door Sunshade) Removal

7. REMOVE REAR NO. 1 SPEAKER ASSEMBLY

(a) Disconnect the speaker connector.

(b) Remove the 2 screws.

(c) Detach the clip and remove the speaker.

NOTICE:
Do not touch the cone part of the speaker.





8. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 19 Speakers)





(a) Disconnect the speaker connector.

(b) Remove the 3 screws.

NOTICE:
Do not touch the cone part of the speaker.

9. REMOVE REAR NO. 3 SPEAKER ASSEMBLY (for 19 Speakers)





(a) Disconnect the connector.

(b) Detach the clamp, and remove the 2 screws and speaker.

NOTICE:
Do not touch the cone part of the speaker.