Removal
DRIVE SHAFT / PROPELLER SHAFT: REAR DRIVE SHAFT ASSEMBLY: REMOVAL
HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.
1. REMOVE REAR WHEEL
2. REMOVE REAR AXLE SHAFT NUT
(a) Using SST and a hammer, release the staked part of the axle shaft nut.
SST : 09930-00010
NOTICE:
Release the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.
(b) While depressing the brake pedal, remove the axle shaft nut.
3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Disassembly
4. REMOVE REAR NO. 1 DISC BRAKE CALIPER PLATE Removal
5. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
6. REMOVE REAR DISC Removal
7. REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR Removal
8. REMOVE REAR SUSPENSION MEMBER BRACE Removal
9. SEPARATE REAR SPEED SENSOR Removal
10. REMOVE NO. 2 PARKING BRAKE SHOE RETURN TENSION SPRING Disassembly
11. REMOVE NO. 1 PARKING BRAKE SHOE RETURN TENSION SPRING Disassembly
12. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET Disassembly
13. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY Disassembly
14. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY Disassembly
15. REMOVE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY Disassembly
16. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY Removal
17. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY Removal
18. SEPARATE TOE CONTROL LINK SUB-ASSEMBLY Removal
19. REMOVE REAR NO. 2 UPPER CONTROL ARM ASSEMBLY Removal
20. SEPARATE REAR NO. 1 UPPER CONTROL ARM ASSEMBLY Removal
21. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY Removal
22. REMOVE REAR AXLE ASSEMBLY Removal
23. REMOVE REAR DRIVE SHAFT ASSEMBLY
(a) Using SST, remove the rear drive shaft assembly.
SST : 09520-01010
SST : 09520-24010
09520-32040
NOTICE:
* Be careful not to damage the oil seal, inboard joint boot or drive shaft dust cover.
* Be careful not to drop the drive shaft assembly.
24. REMOVE HOLE SNAP RING
(a) Using a screwdriver, remove the hole snap ring.
25. INSPECT REAR DRIVE SHAFT ASSEMBLY Component Tests and General Diagnostics