Removal

PARK ASSIST / MONITORING: CLEARANCE WARNING BUZZER: REMOVAL

1. PRECAUTION (w/ Navigation System for HDD)

Service Precautions

NOTICE:
* After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
* A hard disk drive (HDD) is built into the multi-display to store map data etc. which will be used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the multi-display.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Navigation System for HDD)

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission) Removal

4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission) Removal

5. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission) Removal

6. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission) Removal

7. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission) Removal

8. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Removal

9. REMOVE FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Removal

10. REMOVE INSTRUMENT PANEL COIN BOX (w/o Ashtray) Removal

11. REMOVE FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray) Removal

12. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

13. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Removal

14. REMOVE INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (w/o Multi-display) Removal

15. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY WITH RADIO RECEIVER ASSEMBLY (w/ Multi-display) Removal

16. REMOVE CLEARANCE WARNING BUZZER

(a) Disconnect the connector.

(b) Disengage the clamp and remove the clearance warning buzzer.