Removal

FRONT SUSPENSION: FRONT LOWER BALL JOINT: REMOVAL

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. REMOVE FRONT AXLE ASSEMBLY

HINT
Refer to the procedure up to Remove Front Axle Assembly Removal.

2. REMOVE FRONT LOWER BALL JOINT ASSEMBLY

(a) Secure the front axle assembly between aluminum plates in a vise.

NOTICE:
When using a vise, do not overtighten it.

(b) When removing the nut (Type A):

(1) Remove the clip and nut.

(c) When removing the nut (Type B):

(1) Remove the cotter pin and nut.

(d) Install SST to the front lower ball joint as shown in the illustration.

SST : 09960-20010

09961-02050





Text in Illustration





NOTICE:
Check that the clearance measurement between SST and the front axle assembly is 1 mm (0.0394 in.).

(e) Using SST, remove the front lower ball joint assembly from the front axle assembly as shown in the illustration.

SST : 09960-20010

09961-02010

09961-02050





Text in Illustration





CAUTION:
Apply grease to the threads and end of the SST bolt.

NOTICE:
* Install SST so that A and B are parallel.
* Be sure to place a wrench on the part indicated in the illustration.
* Do not damage the front lower ball joint dust cover.