Installation

2AZ-FXE ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL TIMING CHAIN CASE OIL SEAL

(a) Apply MP grease to a new oil seal lip.





NOTICE:
Keep the lip free from foreign matter.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the front oil seal retainer edge.

SST : 09223-22010

NOTICE:
Wipe off extra grease from the crankshaft.

2. INSTALL CRANKSHAFT PULLEY

(a) Align the pulley set key with the key groove of the pulley.





(b) Using SST, hold the pulley in place and tighten the bolt.

SST : 09213-54015

91651-60855

SST : 09330-00021

Torque : 180 Nm (1835 kgf-cm, 133 ft-lbf)

3. INSTALL V-RIBBED BELT Installation

4. INSTALL V-RIBBED BELT TENSIONER COVER SUB-ASSEMBLY Installation

5. INSPECT FOR OIL LEAK

6. INSTALL COOL AIR INTAKE DUCT SEAL Installation

7. INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH

(a) Install the rear side rail reinforcement sub-assembly RH with the 4 bolts.





Torque : 96 Nm (979 kgf-cm, 71 ft-lbf)

NOTICE:
Temporarily tighten bolts A and B, and then fully tighten the 4 bolts in the order of C, B, D and A.

8. INSTALL REAR ENGINE UNDER COVER RH

9. INSTALL NO. 1 ENGINE UNDER COVER

10. INSTALL ENGINE UNDER COVER