Installation

PARKING BRAKE: PARKING BRAKE CABLE: INSTALLATION

1. INSTALL PARKING BRAKE CABLE SUPPORT CLAMP SUB-ASSEMBLY

(a) Engage the 2 claws to install a new parking brake cable support clamp sub-assembly to the No. 3 parking brake cable assembly.

2. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Install the No. 3 parking brake cable assembly with the 5 bolts.

Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

(b) Install the No. 3 parking brake cable assembly to the backing plate with the bolt.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(c) Engage the clamp to install the parking brake cable support clamp sub-assembly.

3. INSTALL PARKING BRAKE SHOE LEVER LH

HINT
Refer to the procedures from "Install Parking Brake Shoe Lever." Reassembly.

4. INSTALL REAR FLOOR SIDE MEMBER COVER LH Installation

5. INSTALL FRONT NO. 2 FLOOR HEAT INSULATOR

(a) Install the front No. 2 floor heat insulator with the 3 nuts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

6. INSTALL FRONT EXHAUST PIPE ASSEMBLY

HINT
Refer to the instructions for Installation of the front exhaust pipe assembly Installation.

7. INSTALL NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY

(a) Connect the No. 3 parking brake cable assembly to the No. 1 parking brake pull rod sub-assembly as shown in the illustration.





(b) Connect the No. 2 parking brake cable assembly to the No. 1 parking brake pull rod sub-assembly.

HINT
Perform the same procedure as for the No. 3 parking brake cable assembly.

8. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY

(a) Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.

(b) Install the clip to the No. 1 parking brake cable assembly.

(c) Bend the parking brake pedal claw.





(d) Temporarily install the adjusting nut.

9. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

HINT
Refer to the instructions for Installation of the parking brake control pedal assembly Installation.