Installation

2GR-FE COOLING: THERMOSTAT: INSTALLATION

1. INSTALL THERMOSTAT

(a) Install a new gasket to the thermostat.





(b) Install the thermostat with the jiggle valve facing up.

HINT
The jiggle valve may be set within 10° on either side of the prescribed position.

2. INSTALL WATER INLET

(a) Install the water inlet with the 2 nuts.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

3. CONNECT RADIATOR HOSE OUTLET Installation

4. INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY Installation

5. INSTALL V-RIBBED BELT Installation

6. INSTALL ENGINE MOVING CONTROL ROD SUB-ASSEMBLY Installation

7. INSTALL NO. 2 ENGINE MOUNTING STAY RH Installation

8. INSTALL FRONT FENDER APRON SEAL RH

9. ADD ENGINE COOLANT Testing and Inspection

10. INSPECT FOR COOLANT LEAK Testing and Inspection

11. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

12. INSTALL ENGINE ROOM SIDE COVER RH

13. INSTALL COOL AIR INTAKE DUCT SEAL