Removal

ENGINE HOOD / DOOR: HOOD LOCK CONTROL CABLE ASSEMBLY: REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal

2. REMOVE HOOD HINGE COVER Removal

3. REMOVE ENGINE ROOM SIDE COVER Removal

4. REMOVE HOOD TO FRONT FENDER SEAL

5. REMOVE FRONT WHEEL

6. REMOVE FRONT WHEEL OPENING EXTENSION PAD

(a) Remove the 3 screws and the front wheel opening extension pad.

7. REMOVE FRONT BUMPER ASSEMBLY Removal

8. REMOVE FRONT FENDER LINER

(a) Remove the 6 clips and 5 screws.

(b) Remove the 2 bolts and the front fender liner.

9. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Removal

10. REMOVE HOOD LOCK ASSEMBLY

(a) Using a screwdriver, remove the hood lock nut cap as shown in the illustration.

HINT
Tape the screwdriver tip before use.

(b) Remove the 2 bolts and nut.

(d) Remove the hood lock assembly.

11. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

(a) Detach the 3 claws.

(b) Disconnect the hood lock control cable and remove the hood lock control lever.

12. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

(a) Using a screwdriver, disconnect the clamps shown in the illustration.

HINT
Tape the screwdriver tip before use.

(b) Pull the cable from the engine compartment and remove it.