Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: REMOVAL

1. REMOVE STEERING WHEEL ASSEMBLY

Removal

2. REMOVE STEERING COLUMN COVER Removal

3. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

NOTICE:
* Do not replace the spiral cable with the auxiliary battery connected and the power switch on (IG).
* Do not rotate the spiral cable without the steering wheel with the auxiliary battery connected and the power switch on (IG).
* Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
* Do not remove the steering sensor from the spiral cable.

(a) Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.





Text in Illustration





NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.

(b) Disconnect the other connector from the spiral cable with sensor sub-assembly.

(c) Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.