Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

(c) Temporarily install the curtain shield airbag assembly with the 5 hooks.

NOTICE:
Do not twist the curtain shield airbag assembly when installing it.

(d) Install 5 new bolts in the order shown in the illustration.





Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

(e) Install the curtain shield airbag assembly to the body panel with 4 new clips and 4 new spacers in the order shown in the illustration





Text in Illustration





(f) Install the 4 pins.

NOTICE:
Make sure that the pins of the clips are pushed in firmly.

(g) Connect the curtain shield airbag connector.





NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

(h) Push in the lock to install the airbag connector.

2. INSTALL ROOF HEADLINING ASSEMBLY

Installation

3. PERFORM DIAGNOSTIC SYSTEM CHECK

Reading and Clearing Diagnostic Trouble Codes