Installation

BRAKE SYSTEM (OTHER): BRAKE PEDAL: INSTALLATION

1. INSTALL BRAKE PEDAL PAD

2. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

(a) Install the nut to the brake pedal support assembly.

(b) Install the brake pedal support assembly with the 4 nuts.

Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

(c) Engage the clamp.

(d) Install the brake pedal support assembly to the instrument panel reinforcement with the bolt.

Torque : 24 Nm (241 kgf-cm, 17 ft-lbf)

3. INSTALL PUSH ROD PIN

(a) Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal sub-assembly.

(b) Install the push rod pin and a new clip to connect the push rod clevis to the brake pedal sub-assembly.

4. INSTALL BRAKE PEDAL RETURN SPRING

(a) Install the brake pedal return spring to the brake pedal support assembly and push rod pin.

5. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

6. INSTALL STOP LIGHT SWITCH ASSEMBLY Installation

7. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY Installation

8. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY Installation

9. INSTALL POWER STEERING ECU ASSEMBLY

Installation

10. INSPECT AND ADJUST BRAKE PEDAL

Adjustments

11. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE

Initialization

12. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation