Pinout Values and Diagnostic Parameters

SLIDING ROOF / CONVERTIBLE: SLIDING ROOF SYSTEM: TERMINALS OF ECU

1. CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)

(a) Disconnect the T10 sliding roof ECU (sliding roof drive gear assembly) connector.





(b) Measure the resistance and voltage according to the value(s) in the table below.

HINT
Measure the values on the wire harness side with the connector disconnected.





If the result is not as specified, there may be a malfunction in the wire harness.

(c) Reconnect the T10 sliding roof ECU (sliding roof drive gear assembly) connector.

(d) Measure the voltage according to the value(s) in the table below.





If the result is not as specified, the sliding roof ECU (sliding roof drive gear assembly) may have a malfunction.