Removal

NAVIGATION / MULTI INFO DISPLAY: HARD DISK DRIVE: REMOVAL

1. PRECAUTION

Navigation System (For HDD)

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work Service Precautions.

2. REMOVE REAR NO. 2 FLOOR BOARD Removal

3. REMOVE REAR DECK FLOOR BOX Removal

4. REMOVE REAR NO. 3 FLOOR BOARD Removal

5. REMOVE DECK FLOOR BOX RH Removal

6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE Removal

7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for Metal Finish Panel and Urethane Panel) Removal

9. REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for Wood Panel and Bamboo Panel) Removal

10. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL Removal

11. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Removal

12. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH Removal

13. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

14. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

15. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY Removal

16. REMOVE AIR CONDITIONING CONTROL ASSEMBLY Removal

17. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET Removal

18. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY ASSEMBLY WITH BRACKET Removal

19. REMOVE HARD DISK DRIVE

(a) Remove the 2 screws.





(b) Using a screwdriver, pull out the hard disk drive in the direction shown by the arrow in the illustration to remove it.





Text in Illustration





HINT
Tape the screwdriver tip before use.