Installation

REAR SUSPENSION: TOE CONTROL LINK: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. TEMPORARILY TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY

(a) Install the toe control link sub-assembly and insert the toe adjust cam from the front of the vehicle. Then, install the toe adjust plate and temporarily tighten the nut.





Text in Illustration





NOTICE:
Align the matchmarks on the rear suspension member sub-assembly and toe adjust plate.

(b) Install the toe control link sub-assembly with a new nut.





Torque : 70 Nm (714 kgf-cm, 52 ft-lbf)

2. INSTALL REAR SPEED SENSOR WIRE

(a) Install the rear speed sensor wire with the bolt.





Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

(b) Connect the rear speed sensor wire connector.

3. STABILIZE SUSPENSION Installation

4. FULLY TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY

(a) Fully tighten the nut while holding the toe adjust cam.





Text in Illustration





Torque : 50 Nm (510 kgf-cm, 37 ft-lbf)

NOTICE:
* Check that the matchmarks on the rear suspension member sub-assembly and toe adjust plate are aligned.
* The final torque must be applied under standard vehicle height conditions.

5. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

6. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

Rear Wheel Alignment.

7. CHECK FOR SPEED SENSOR SIGNAL

Test Mode Procedure.