Installation

2GR-FSE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL ENGINE REAR OIL SEAL

(a) Apply MP grease to the lip of a new oil seal.

NOTICE:
Keep the lip free of foreign matter.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.





SST : 09223-15030

SST : 09950-70010

09951-07150

NOTICE:
* Wipe off extra grease of the crankshaft.
* Keep the lip free of foreign matter.
* Do not tap on the oil seal at an angle.

2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

(a) Using SST, hold the crankshaft pulley.





SST : 09213-70010

09213-70020

SST : 09330-00021

(b) Clean the 8 bolts and 8 bolt holes.

(c) Install the front drive plate spacer.





HINT
Align the pin of the front drive spacer with the pin hole of the crankshaft.

(d) Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.





Text in Illustration





(e) Apply a few drops of adhesive to 2 or 3 threads of the 6 bolt tips.





Text in Illustration





Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

(f) In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.





Torque : 83 Nm (846 kgf-cm, 61 ft-lbf)

3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

HINT
See the steps from "Install Automatic Transmission Assembly" through "Install V-bank Cover Sub-Assembly" Installation.

4. INSPECT FOR OIL LEAK