Installation

A960E AUTOMATIC TRANSMISSION: SHIFT LEVER ASSEMBLY: INSTALLATION

1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

(a) Install the floor shift assembly with the 4 bolts.





Torque : 8.3 Nm (85 kgf-cm, 73 in-lbf)

(b) Connect the connector to the floor shift assembly.

2. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

(a) Install the floor shift gear shifting rod sub-assembly with the nut.





Torque : 13 Nm (133 kgf-cm, 9 ft-lbf)

3. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR Installation

4. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

5. INSTALL OXYGEN SENSOR Installation

6. INSTALL FRONT CENTER FLOOR BRACE Installation

7. INSTALL REAR NO. 1 FLOOR PANEL BRACE Installation

8. INSTALL NO. 2 FLOOR UNDER COVER Installation

9. INSTALL NO. 1 FLOOR UNDER COVER Installation

10. INSTALL NO. 2 CONSOLE BOX DUCT Installation

11. INSTALL CONSOLE BOX Installation

12. INSTALL CONSOLE BOX REGISTER ASSEMBLY (w/ Ashtray) Installation

13. INSTALL CONSOLE BOX REGISTER ASSEMBLY (w/o Ashtray) Installation

14. INSTALL FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray) Installation

15. INSTALL INSTRUMENT PANEL BOX ASSEMBLY (w/o Ashtray) Installation

16. INSTALL CONSOLE PANEL SUB-ASSEMBLY Installation

17. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH Installation

18. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH Installation

19. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

20. ADJUST SHIFT LEVER POSITION Adjustments

21. INSPECT SHIFT LEVER POSITION Shift Lever Assembly

22. INSPECT FOR EXHAUST GAS LEAK Installation