Installation

SEAT BELT: REAR SEAT OUTER BELT ASSEMBLY: INSTALLATION

1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY

(a) Engage the guide.





(b) Fully tighten the bolt [A] first, then the bolt [B] to install the front seat outer belt assembly.

Bolt A - Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

Bolt B - Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

(c) Connect the connector.

(d) Check if the ELR locks.

NOTICE:
The check should be performed with the rear seat 3 point type belt assembly installed.

(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.

2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)

(a) Engage the 5 guides as shown in the illustration.





(b) Engage the 3 clips to install the package tray trim panel assembly.

3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade) Installation

4. INSTALL CENTER STOP LIGHT SET (w/o Rear Sunshade) Installation

5. INSTALL REAR SEAT SHOULDER BELT COVER

(a) Engage the 4 claws to install the rear seat shoulder cover.





HINT
Use the same procedure for the other 2 rear seat shoulder covers.

6. CONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH Installation

7. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH Installation

8. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH

(a) Connect the floor anchor end of the rear seat 3 point type belt assembly LH with the bolt.





Text in Illustration





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

NOTICE:
Do not allow the anchor part of the rear seat 3 point type belt assembly LH to overlap the protruding part of the floor panel.

9. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH

(a) Connect the floor anchor end of the rear seat 3 point type belt assembly RH with the bolt.





Text in Illustration





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

NOTICE:
Do not allow the anchor part of the rear seat 3 point type belt assembly RH to overlap the protruding part of the floor panel.

10. INSTALL REAR SEATBACK ASSEMBLY Installation

11. INSTALL REAR SEAT HEADREST ASSEMBLY LH Installation

12. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY Installation

13. INSTALL REAR SEAT HEADREST ASSEMBLY RH Installation

14. INSTALL REAR SEAT CUSHION LOCK HOOK Installation

15. INSTALL REAR SEAT CUSHION ASSEMBLY Installation

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Installation

17. INSTALL LUGGAGE COMPARTMENT FLOOR MAT Installation

18. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.