Removal

SEAT BELT: FRONT SEAT INNER BELT ASSEMBLY: REMOVAL

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the RH side.
* A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

(a) Disengage the 6 guides and remove the seat belt anchor cover cap as shown in the illustration.





(b) Move the seat using the power seat switch knob so that the seat belt anchor bolt is revealed.

(c) Remove the bolt and front seat outer belt anchor.





2. REMOVE FRONT SEAT ASSEMBLY





Operate the power seat switch knob and move the seat to the rearmost position.

(a) Using a screwdriver, disengage the 4 claws and remove the 2 front seat track bracket covers.

HINT
Tape the screwdriver tip before use.

(b) Remove the 2 bolts on the front side of the seat.

(c) Operate the power seat switch knob and move the seat to the foremost position.





Using a screwdriver, disengage the 4 claws and remove the front seat track rear outer cover and front seat track rear inner cover.

(d) Remove the 2 bolts on the rear side of the seat.

(e) Disconnect the cable from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Service Precautions.

(f) Disconnect the connectors under the seat. Then remove the seat.

NOTICE:
Be careful not to damage the vehicle body.

3. REMOVE FRONT SEAT INNER BELT ASSEMBLY





Disconnect the connector.

(a) Remove the seat belt's wire harness clamp.

(b) Remove the nut and seat belt.